Vacuum belts are rubber belts that drive the rotation of the brush roll.
This is easier if you can remove the brush roll, but you should still be able to cut away tangles without removing the brush.It can be quite tricky to pull out all the hair and carpet fibres that are stuck in the bristles, so this step may take some time.. Soft roller.
Again, snip away hair that’s looped around the brush, but be careful not to damage the softer fabric of this brush roll.Then use a dry cloth to wipe any excess dust from the soft roller.If you want to give it a deeper clean after removing the soft roller, you can use cold water (no soap) – but allow it to fully dry for at least 24 hours before reinserting the brush roll.. What About Shark’s Anti Hair-Wrap Technology?.
Shouldn’t Shark’s anti hair-wrap technology prevent hairs from becoming caught around the brush roll?.The answer is “sometimes.” While the anti hair-wrap system does a good job at removing most hairs, it doesn’t remove them all.
You’ll still need to manually remove caught hairs and carpet fibres from the brushes..
Step 5: Clean Non-Motorised Tools.Ideally, you want one without a rotating brush bar or the option to switch it off when cleaning vinyl floors.. Do you have any questions about cleaning vinyl floors?
Please let us know in the comments section below.And if you’re looking for a vacuum for vinyl, check out.
our top cordless models for hard floorsBroken glass can be a nightmare to clean up – but is it safe to use your vacuum cleaner?Keep reading to find out..
(Editor: Silent Smartphones)